Thermal Expansion Calculator
How much does a part grow or shrink when its temperature changes? Enter a length, a material and two temperatures. Works for heating and cooling, with a constant or a temperature-dependent expansion coefficient. Free, no sign-up, nothing leaves your device.
Length change against temperature
Move the pointer over the blue line or over a red point to read the temperature, the change in length and the length. The small orange dots mark every whole degree (the pointer snaps to them).
How it works
Constant α. The usual formula is ΔL = α · L0 · ΔT: the change in length equals the coefficient of linear expansion α, times the starting length L0, times the temperature change ΔT. A temperature change of 1 K is the same as 1 °C, so α per K and per °C are the same number. If the temperature falls, ΔT is negative and the part shrinks. The value of α in tables is an average over a range around room temperature, which is accurate enough for moderate temperature changes.
α that changes with temperature. The real coefficient is not constant: it is smaller when it is cold and grows with temperature. For large temperature changes, the length is found by adding up the small changes: L(T2) / L(T1) = exp( ∫ α(T) dT ) from T1 to T2. The page offers two ways: a straight-line change of α with temperature that you describe yourself (α at the starting temperature plus β per kelvin), and, for four materials, a published fit from NIST that is valid only from 4 K to 300 K (−269 °C to 27 °C).
Comparison table. Shows what the same length and the same temperatures would give for the other materials, using their typical constant α. The bar is the size of the change relative to the largest one.
Typical values and sources
The typical values of α (near 20 to 25 °C) and their ranges come from public tables: Engineering ToolBox, linear expansion coefficients and HyperPhysics, thermal expansion coefficients at 20 °C. Where a source gives a range, the page shows the middle of it as the typical value and the range next to it. Real materials differ with alloy, grade, heat treatment and manufacturing: for a design, use the datasheet of the material you buy.
The NIST fits (linear expansion, valid 4 K to 300 K, stated curve-fit error between 1.5% and 10% of the data) are from the NIST cryogenic material properties pages: 6061-T6 aluminium, 304L stainless steel, OFHC copper and Ti-6Al-4V titanium. They describe those specific alloys, so for other grades of the same metal they are only an approximation. This page is not affiliated with NIST. Last checked: 7 November 2026.
Limits you should know
- The result is the free expansion of a uniform part at a uniform temperature. A part that is held in place, or parts with different temperatures, behave differently.
- The page treats a length in one direction. Materials with different properties in different directions (composites, wood, some crystals) need the α of that direction.
- Plastics change a lot with temperature, humidity and grade: the ranges in the table are wide.
- Near a phase change or glass transition the coefficient jumps, and no simple formula applies.